.gif)
.gif)
Industry News
August 27, 2010
Americans Using Less Energy, More Renewables
Americans are using less energy overall and making more use of renewable energy resources. The United States used significantly less coal and petroleum in 2009 than in 2008, and significantly more wind power. There also was a decline in natural gas use and increases in solar, hydro and geothermal power according to the most recent energy flow charts released by the Lawrence Livermore National Laboratory (LLNL).
"Energy use tends to follow the level of economic activity, and that level declined last year. At the same time, higher efficiency appliances and vehicles reduced energy use even further," said A.J. Simon, an LLNL energy systems analyst who develops the energy flow charts using data provided by the Department of Energy’s Energy Information Administration. "As a result, people and businesses are using less energy in general."
The estimated U.S. energy use in 2009 equaled 94.6 quadrillion BTUs ("quads"), down from 99.2 quadrillion BTUs in 2008. (A BTU or British Thermal Unit is a unit of measurement for energy, and is equivalent to about 1.055 kilojoules). The average American household uses about 95 million BTU per year.
Related: Ambient Joins G3-PLC Alliance to Enhance PLC and Offer Greater Choice
Energy use in the residential, commercial, industrial and transportation arenas all declined by .22, .09, 2.16 and .88 quads, respectively. Wind power increased dramatically in 2009 to.70 quads of primary energy compared to .51 in 2008. Most of that energy is tied directly to electricity generation and thus helps decrease the use of coal for electricity production.
"The increase in renewables is a really good story, especially in the wind arena," Simon said. "It’s a result of very good incentives and technological advancements. In 2009, the technology got better and the incentives remained relatively stable. The investments put in place for wind in previous years came online in 2009. Even better, there are more projects in the pipeline for 2010 and beyond."
Opinion: Local Power Distribution with Nanogrids
The significant decrease in coal used to produce electricity can be attributed to three factors: overall lower electricity demand, a fuel shift to natural gas, and an offset created by more wind power production, according to Simon.
Nuclear energy use remained relatively flat in 2009. No new plants were added or taken offline in this interval, and the existing fleet operated slightly less than in 2008. Of the 94.6 quads consumed, only 39.97 ended up as energy services. Energy services, such as lighting and machinery output, are harder to estimate than fuel consumption, Simon said.
The ratio of energy services to the total amount of energy used is a measure of the country’s energy efficiency. Carbon emissions data are expected to be released later this year, but Simon suspects they will tell a similar story.
"The reduction in the use of natural gas, coal and petroleum is commensurate with a reduction in carbon emissions," he said. "Simply said, people are doing less stuff. Therefore, they’re burning less fuel."
Share this story
Send via E-mail
Post to Twitter
On the Web:
White Papers
March 11, 2013
Power Modules for Charger Applications
Sponsored by Vincotech
February 27, 2013
The Adaptive Cell Converter Topology Enables Constant Efficiency Over Universal Input AC Line in Front-End, High-Density Power Factor Correction Applications
Sponsored by Vicor Corp.
February 27, 2013
From 48 V direct to Intel VR12.0: Saving "Big Data" $500,000 per datacenter, per year
Sponsored by Vicor Corp.
More White Papers
- Ericsson Delivers 750W Quarter-Brick using Proprietary HRR Topology
- IXYS Introduces an Anode-Gated Thyristor Technology Platform
- Dreamliner Nightmares a Factor in New UL Standards Activities for Li-ion Batteries
- Ideal Diode Bridge Controller Minimizes Rectifier Heat and Voltage Loss
- Siemens Installing Regenerative Energy Storage Unit on Light Rail Line
- Silicon Labs acquires Energy Micro for IoT, Smart Energy and Portable Electronics
- NXP Brings High Efficiency to 12V MR16 Lamps with Dimmable LED Controller
- Ultra-Compact High-Efficiency Power Supplies for Automotive Applications
- Curtis Industries Acquires California-based Tri-Mag
- Convection-Cooling Eliminates Fan Maintenance and Audible Noise in 250W Power Supplies
- Siemens Installing Regenerative Energy Storage Unit on Light Rail Line
- Ericsson Delivers 750W Quarter-Brick using Proprietary HRR Topology
- Single-Stage LED Drivers Deliver Dimming and Thermal Protection with Lower BOM Cost
- Convection-Cooling Eliminates Fan Maintenance and Audible Noise in 250W Power Supplies
- ABB Demonstrates Technology to Power Flash Charging Electric Bus in 15 Seconds
- GE Intros Megawatt UPS Global Platform with Industry-Leading Efficiency
- Dreamliner Nightmares a Factor in New UL Standards Activities for Li-ion Batteries
- Dow Corning adds Thermal Management Options Optimized for Electronics Applications
- ICCNexergy Adds Line of Lithium-Iron-Phosphate Batteries for Medical Carts
- Sungrow Presents New PV Inverters Again at Intersolar 2013
- Green Building Power Forum 2010: Fujitsu Components America
- Darnell's Digital Power Forum 2009: CUI Incorporated
- Green Building Power Forum 2010: EMerge Alliance
- Green Building Power Forum 2010: Anderson Power Products
- Green Building Power Forum 2009: Independence Station
- Darnell's Digital Power Forum 2009: Coilcraft
- Darnell's Digital Power Forum 2009: Champs Technologies
- Darnell's Digital Power Forum 2009: EXAR Corporation
- Darnell's Digital Power Forum 2009: PMBus
- Darnell's Digital Power Forum 2009: Power Plaza
Design Features
October 22, 2012
Energy Efficiency with Class D Amplifier Modules
Class-D switching amplifiers are helping audio designers create personal multimedia devices and home audio/visual systems that demonstrate how compact and stylish equipment can also deliver high sound quality and high audio output power. The key to this breakthrough, providing freedom from the large and bulky boxes housing traditional audio products, lies in the class-D amplifier’s high energy efficiency, which is typically around 90%. This allows designers to reduce or eliminate heatsinks as well as using smaller-sized PCBs and smaller components such as transformers, connectors and power supplies.
Design Features
October 8, 2012
The Role of Hall Effect Sensors in Power Distribution Infrastructure
Power distribution units (PDUs) form an essential part of modern computing and data communications hardware. They provide multiple outputs for transferring electrical power with maximum efficiency, controlling the power capacity and safeguarding against the possible causes of supply interruption. With an ever increasing need from tech savvy consumers for higher data throughput and greater quantities of data storage capacity, as well as tough international legislation now governing CO&sub2; emissions, the demands being placed on these units are proving challenging for engineering teams to satisfy.
Product Focus
August 13, 2012
The Year in AC-DC Power Supply Technology
The past year witnessed significant new product releases, technological developments, and industry news related to the field of AC-DC Power Supply technology.